This previous week, along the Patch Tuesday updates for November 2024, the corporate launched its corresponding Setup and Recovery dynamic updates for Windows 11. However, it is usually a type of uncommon instances when Dynamic updates for Windows 10 have additionally been launched, and there are a number of.

However, one of the most Recovery updates, KB5048239, could also be resulting in set up screw ups with the “0x80070643” error.

For instance, Sebastian94 at the Windows 10 Forums writes, “KB5048239: Another poor update of WinRE?”

Another person, dritzTX, at the Microsoft discussion board, has printed the similar question headlined “Security Update for Windows 10, 2024-11, KB5048239 getting error 0x80070643 when installing”. The person is going on to jot down:

I’ve precisely the similar drawback as this (reported previous this 12 months), however with the brand new KB5048239 replace. I am getting the 0x80070643 error when it tries to put in. Retried a number of instances, however identical factor. I’m lovely certain this is similar drawback that I had again in January, too. All safety updates have labored advantageous since then, until now.

At that point I used to be advised that this was once a basic drawback with the replace and a repair was once being made through Microsoft. I did wait and sooner or later that earlier replace went away. Now right here we’re once more…

The person has mentioned as it should be {that a} equivalent factor popped up previous in which a Windows Recovery Environment (WinRE) updates KB5034440 / KB5034441led to the “0x80070643 – ERROR_INSTALL_FAILURE” error message, and Microsoft needed to sooner or later pull them and exchange them with KB5042321 / KB5042320.

The screw ups are a results of inadequate Windows Recovery partition area, because it calls for no less than 250 MB, and Microsoft is easily conscious about this. It writes:

NOTE This replace calls for 250 MB of loose area within the restoration partition to put in effectively.

If you wish to be sure your tool is obtainable this replace, please apply the  Instructions to manually resize your partition or use a pattern script to extend the scale of the WinRE restoration partition.

Once your partition has enough disk area, click on Start > Settings > Windows Update > Check for updates to have the replace presented to you after which set up it.

We have already lined those workarounds prior to now. You can to find them right here: Instructions for guide Recovery pressure resize information (dated: July 21, 2024) || PowerShell script.